ed-bradley
17th November 2011, 19:45
Evening all, I've got a couple of queries about my VTS conversion.
Would be better if I had pictures, but I dont sadly. I'm hoping somewhere here can provide some :D
-Firstly, I've got a Grey plug, on the cambelt side of the engine near the Ecu, that is currently going to nothing. I've read that there may be a sensor I'm missing from this side of my Inlet manifold? Or that it may be for the Carbon canister.
-Also, me being the tit I am,I didn't take note of where some bits went when taking the old engine out.. I've got a hose that needs to come from the Brake servo to the Inlet (I think) But don't no where exactly. Theres a small bit of hose dangling from the middle of my inlet manifold with nothing on? Should it be going to the same place as this? or the small pipe/outlet on the end of my fuel rail, that currently has nothing on?
Thanks, Ed.
Would be better if I had pictures, but I dont sadly. I'm hoping somewhere here can provide some :D
-Firstly, I've got a Grey plug, on the cambelt side of the engine near the Ecu, that is currently going to nothing. I've read that there may be a sensor I'm missing from this side of my Inlet manifold? Or that it may be for the Carbon canister.
-Also, me being the tit I am,I didn't take note of where some bits went when taking the old engine out.. I've got a hose that needs to come from the Brake servo to the Inlet (I think) But don't no where exactly. Theres a small bit of hose dangling from the middle of my inlet manifold with nothing on? Should it be going to the same place as this? or the small pipe/outlet on the end of my fuel rail, that currently has nothing on?
Thanks, Ed.