Spraying Alloys

[link_heroz]

how would i go about spraying them a new colour? they're the standard saxo alloys and i can't afford a new set so i was thinking of spraying them to give them a facelift for a few quid.

[Dano]

how would i go about spraying them a new colour? they're the standard saxo alloys and i can't afford a new set so i was thinking of spraying them to give them a facelift for a few quid.

Learn to search mate, been covered 1000's of times

[link_heroz]

is there a search bit? sorry, i'm new to the forum so still learning where everything is.

[Dano]

is there a search bit? sorry, i'm new to the forum so still learning where everything is.

Yup top right corner "Search"

Also look at the FAQ's bit at the top of the styling and interior section :y:

[martinstfc]

Get a can of spray paint give um a good clean first then spray um won't look amazing but it will also not cost any more than a 10er

[Dano]

Get a can of spray paint give um a good clean first then spray um won't look amazing but it will also not cost any more than a 10er

And the winner for worst advice of the year goes too.........

[link_heroz]

got a how to page, thanks.

[martinstfc]

Yeah and the 200 pound I save

[brainbug]

just done mine gloss black.

2 tins high build primer, 2 tins gloss black paint, 2 tins clear lacquer = £24

this did all 4 wheels and still have a full tin of clear lacquer left.

you'll need some wet and dry sandpaper aswell, only a few pence per sheet.

take your time and they'll turn out ok.

[logic_guy]

Paint stripper ftw and bring them back to bare metal and start from there.

Filler, High build primer, numerous sand paper grades etc

[logic_guy]

I'd also suggest sugar soaping (like a de-greaser) each time you apply a coat of paint.

[Bedford126]

Paint stripper ftw and bring them back to bare metal and start from there.

Filler, High build primer, numerous sand paper grades etc

I'd also suggest sugar soaping (like a de-greaser) each time you apply a coat of paint.

Bad bad bad advice. Never strip anything back to bare metal unless you really have to moisture effects it and the finished product. Second of all there is no need for sugar soap after the initial clean and even then I wouldn't suggest using it. Best to use a solvent such as paint thinners or metholated spirit.