Respraying alloys! Helpp

[WickedRedSaxo]

Right, i have started a DIY respraying my alloys, im fine with all the sanding priming, however when i sprayed the first layer of black paint it was fine, then the second layer i sprayed into one of the nut hole but accident and some sort of dust flew out and landed on the paint, which then i was stupid enough to attempt to get rid of it, which left a mark, when i sand it, it seems to have left a patch of missing layer (if you get me) , what is the best solution to this? as the other part of the alloy are fine , do i just sand it with some p800 sanding paper until its gone? or will i need to prime it again?

Using can's !
and sorry about the long story (:
any help?

Many thanks !!

[Cam]

Very gently use 1200 wet and dry make sure its wet and gently rub it till your happy, then once your happy if its only prima just give it a nice little spary over :)

[Ben_SaxoForte]

I would probably smooth out the rough area the best I could with the fine grit paper then spray some primer over that area and smooth that out once dry then carry on painting

[WickedRedSaxo]

I would probably smooth out the rough area the best I could with the fine grit paper then spray some primer over that area and smooth that out once dry then carry on painting

would it affect the coating if say i sprayed primer then paint then primer again?

thanks !

[WickedRedSaxo]

Very gently use 1200 wet and dry make sure its wet and gently rub it till your happy, then once your happy if its only prima just give it a nice little spary over :)

when you say make sure its wet , do you mean the sand paper or the paint? haha XD just confused (:

thanks !

[bainesy2011]

when you say make sure its wet , do you mean the sand paper or the paint? haha XD just confused (:

thanks !

the sand paper