Limp mode after fitting 4-2-1 manifold Help!

[curt272]

fitted 1st lambda sensor in the manifold and 2nd is in the engine bay and its still in limp mode :/, if i disconnect the battery and leave it for a while will it reset the ecu and be okay ?

[dolby20]

Ecu resets after 10 minutes of being unplugged
But best bet is overnight
Problem is, it then would be better with a run out so I can get sensors going again :/

[curt272]

Ecu resets after 10 minutes of being unplugged
But best bet is overnight
Problem is, it then would be better with a run out so I can get sensors going again :/

not worked :( left it half an hour and still wont go past 3000rpm :@

[dolby20]

not worked :( left it half an hour and still wont go past 3000rpm :@

as said, try overnight?

[Barry123]

VTR has a Cat in the mani, doesn't it?

I suspect you've put the downstream lambda into the manifold, when you should've put the upstream one in. Unfortunately you won't be able to reset the ecu even by leaving it for reminder of the life of the solar system, you'll have to get the fault cleared by a friendly garage.

[curt272]

as said, try overnight?

will do see tomorrow fingers crossed

[dolby20]

will do see tomorrow fingers crossed

see the guy above....
if you plugged it in by accident, its fucked until cleared basically...

[curt272]

VTR has a Cat in the mani, doesn't it?

I suspect you've put the downstream lambda into the manifold, when you should've put the upstream one in. Unfortunately you won't be able to reset the ecu even by leaving it for reminder of the life of the solar system, you'll have to get the fault cleared by a friendly garage.

Oh :/ what do the garage need to do? So i can ask how much it will be, running low on cash at the moment, cheers

[AnthonyMartin]

would be cheap enough to get done. a diagnostic test is about £20 where i live. so u would suspect about that much myself mate :)

[curt272]

would be cheap enough to get done. a diagnostic test is about £20 where i live. so u would suspect about that much myself mate :)

Orite cheers mate :)

[saxovtrmk1]

Hey if you come to me al reset the ecu for a tenner got code reader as im in the garage trade

[sam_16v]

Hey if you come to me al reset the ecu for a tenner got code reader as im in the garage trade

highly recomend this guy he's good :y: