surely no !

[Jaz]

Got black diamond grooved discs on the front with pads, took 250 mile 2 bed them in, gettin a vibration through the steering wheel cud they b warped already ? only done about 1000 miles on them

[DarylVTR]

no they wont be, vibration through the steering wheel could be your alignment or many different things. Check it over, make sure you installed the disks correctly.

It is known for saxos to do this at about 80mph anyway specially lower models.

[hesslevtr]

im asuming this is when braking

[Jaz]

It is when braking yes, checked over the front end also noticed that ma tyres are wearing out on the inside,It's had 2 allignment checks in the last 6 months, The discs where marked right n left, also the guy that fitted them is quite a perfectionist, so i doubt it's a lack of copper slip on the pads etc

[VTaaRon]

check that the brakes are completely blead as they might not be working together or only one side is working etc

[Jaz]

Ahh there an idea, tends 2 drag you about, if u stamp on them, Cheers ron

[Jaz]

Av also read about the engine mount under the Ecu, av had the gearbox one changed recently, i nkow this is gonna sound stupid but where is the Ecu located, it's a mark 2 vts 2002:Y:

[hesslevtr]

its on the left hand side of the engine

[stevenet15]

check that the disks have been put on with the two line up pins i seen when people have put a dosk on top and make it shake when braking, do you understant what i mena the two little pins on the hub that the disk goes onto

[l1ukeRS]

did u tighten your wheels back up properly?

obvious thing to do but ive seen it done

[Jaz]

Cheers for all the replies guys, nah am no really that sure steve, am gonna have a look thou, i'll report back