Want the front lower...

[Deann]

Sup guys, urm question here.
I've been looking around on the net and I can only find coilovers that go down 65mm and my ebay specials that are maxed out at 70mm.
I know people have taken their saxos lower but how is it possible?
Is it a case of, god forbid, cutting coils? :\

[m11ler]

Most people are using gaz coilovers with custom 5 inch springs made by faulkner.

[jasonmayall]

As above.
If you get some GAZ on there, they will handle so much better than your ebay specials...
Which ones are they anyway?
GAZ will also make custom springs if you give them a call and ask :)

Edit: Speak to LSOfreak I know he's seriously low on coilies.

[LSOfreak]

here i am :)

as said, 5 inch custom springs are required.

although its not quite as simple as that. Lower than like 75/80mm and you start getting bottoming out issues and rubbing problems. Can all be sorted ofcourse just takes some time and bit of grinding/relocating pipes

[AXracing]

Going low and making the car still usable is very hard. Standard pump stops on the front come in at about two inches. Standard rear shocks bottom out a little over three inches.

[LSOfreak]

my front bump stops are about half an inch thick :fcuk: lol