hmmm, more mesh!!!

[Qucifer666]

i have a saxo forte, i want the front grill meshed, but to unlock my bonet, i have to pull a catch in the passanger footwell, and then a leaver in the bonet by putting my hand through one of the gaps. can i still mesh it and can i take off the latch under the bonet!

cheerz, Q

[TU-Tuning]

Most people cut a little hole for your fingers on the MK2's mate. Then a little strip of rubber is usually put around the sharp bits so you dont cut your finger and get aids. You and your mesh eh lol

[Qucifer666]

alrite, cheerz.
is there not anyway to undo it.
and fir the mesh well, i think it looks different, lmao!

[TU-Tuning]

Not without making some kinda different popper mechanism i dont think? Shame its a MK2 really, on the MK1 it doesnt matter if you mesh it. I was going to do it on mine but every sax in my area with the VT kit seems to have it done, stock looks more unusual lol.

The little hole doesn't really notice that much btw, you only have to make enough room for a finger or two to fit through.

[Qucifer666]

alrite, cheerz man

[Barry123]

There's what i did with mine.

http://www.saxperience.com/members/adsayer/6DBAF_IMGP1874.jpg

[Saxoladlesta]

Yes you can mesh the whole grill & then still manage to get your fingers underneath the bonnet give it a try ;)

[Qucifer666]

thanx for the help on that, mite give it a go 2morrow, well today!!
but i am afraid to say, i think i will keep the other mesh in the air vents for now!!!, lol

[Saxoladlesta]

Well just pretend you havent got the grill opening and try and open it from underneath the bonnet :)

[Qucifer666]

lol, ok
also a question i shud of asked that is quite important, how to i fix it down,?? and how easy do the slats cum out?

[pricey_vtr]

you can silicone seal it down to the metal or use cabels ties its up to you

[MatM]

I cut out my slats with a jigsaw, i havnt cut a hole for the bonnet catch just leave a small screw driver in your car and flip it up through the mesh. Didnt want to cut the mesh which i spent hours doing lol. I sealed the mesh in with some fixing mould. Check out my pics in the picture section named progress pics :-)

[Qucifer666]

yh, i seen that. Looks good.