christoph
26th September 2012, 14:29
Right, so got my new 1.4 in, got a vtr loom (which i was told will be the right one, still skeptical) but basicly, got round to plumbing in the inlet. But i have a few issues. .
one there are connections on there which aren't on the loom? ?
Two i can't figure out where the fuel lines go, i was under the impression my spi injection one would fit in, hope i'm not wrong and lastly. .
there seems to be clips and holder round the inlet from the throttle body, to little like vacuum holes going into the injectors, i presume how the fuel gets in, none of which i have :n:
If someone could put up some pictures of there 1.4 set-up so i can compare i would be very grateful!
one there are connections on there which aren't on the loom? ?
Two i can't figure out where the fuel lines go, i was under the impression my spi injection one would fit in, hope i'm not wrong and lastly. .
there seems to be clips and holder round the inlet from the throttle body, to little like vacuum holes going into the injectors, i presume how the fuel gets in, none of which i have :n:
If someone could put up some pictures of there 1.4 set-up so i can compare i would be very grateful!