EML on after CAT change

[Dandan090]

any one have any ideas, checked checked and double checked all wires are connected to the right points. so anyone have a clue? im lost :(

[Mochachino]

Mk1 or 2? If its two have you connected the sensors the correct way around?

[Dandan090]

MK2 yeah all the sensors are connected properly all nuts are tight :/ i just cant work it out.

[f13sta]

May just be a stored fault. Needs to be plugged in at a garage.

[Dandan090]

Ok cheers I will give that a try :-)

[stevo67]

Ok cheers I will give that a try :-)

Or buy yourself a cheap fault scanner off ebay.:y:

[Dandan090]

Might do.. Would work out cheaper. This cars turning into a money well! Any chance that if I unplug ecu it would reset the light?

[Karlb1]

Can always try a 'soft' reset. unhook the battery overnight or something and see if it sorts itself out. Does the car run okay?

[Dandan090]

Car runs fine, if not better than it did before. I'll unplug the battery tonight and leave it see if it sorts the problem out cheers mate :-)

[Karlb1]

Cant imagine it being lambda problems if the cars running fine, most cars will run a bit rough if something like that, see if the battery trick sorts it, if not can always pull the fuse for the ecu out for a few mins to reset it too, works on my car but not sure if the ecu has a fuse on the saxo

[Dandan090]

Yeah gonna do the battery tonight, if that don't work any saxo owners know of there is a fuse or relay or something for the ecu to reset it? Thanks :-)

[Dandan090]

Somehow from changing the cat yesturday and have EML on I started it today and no EML so it could just have been the fact it was a new cat and it my engine got all excited thinking i was treating it lol