Angels to smoked

[saxp666]

Got angels in at the minute but just smoked my old headlights and thinking about putting them back in any know if it is hard to change back? Just thinking about wires that's all! Thanks

[mlawlan69]

Currently thinking the same haha, got loads of connectors from scrappy so just a case of soldering them back I'd guess!!!

[Bedford126]

Go to the scrappers then snippy snippy then go home get a chair and solder away. Easy if you can solder.

There is also a site linked on here somewhere that sells all the o.e plugs for the headlights so you would just need to buy them and crimp them on.

[DavidsVTR]

The original plug for the sidelights at each angel headlight will be chopped off (most likely) and connected onto the wires leading to the halo rings.

You'll need to go to scappy (as above :y:) and chop 2 of these plugs off so you can crimp them back together and plug back into the original light....

Be sure that when you cut them off... you have left enough wire on it to connect back onto :y:

[saxp666]

This sounds tuff ha I think there are just wired to side light I thought if I took the wires out then crimped the side light back up and just swapped everything else over main beam etc

[DavidsVTR]

This sounds tuff ha I think there are just wired to side light I thought if I took the wires out then crimped the side light back up and just swapped everything else over main beam etc

Yes thats correct!

The main beam ETC.. will all still have plugs on them.

It's just the sidelights that need crimping though... which in easy enough :y:


good luck ;)