harness mounting points

[GTuff]

just got my buckets in and have a 3/4 point harness now my question is

where do i mount the seat belts

im guessing rear seat belt plug holes and where the seat belt runner is on the outside side of the seat but where do i bolt the inner bit (ie near the handbrake)
:panic::panic::panic:

[AzzAW93]

is there no tag on the subframe for the harness to clip too?
if not you will have to make your own :)

[wadoryu]

Weld a bolt in.

[GTuff]

right ok might mount a plate on top of the tunnel

anyone fancy posting some pics of their set up???

[piranhamatt]

Mine, with back seats mounted one on the seat belt thing on B pillar. 2 on the bar next to door, and the front left - where the back right seat mounts in

[DavidsVTR]

My seats have original saxo subframes welded on... so i got the standard bolt hole from the original seatbelt for me to screw in an eyebolt :y:

[AlexB]

Drill a hole in the tunnel and put spreader plates in by the exhaust for the eyebolt to thread into

Its the only safe way

[tom_vts16v]

i have mine bolted to rear seat belt clip in the middle then the right bolted to the bottom where standard belt bar was and the left onto the floor where seat mounts but i have just bought a eyelet kit which will be fitted in the near future.

[GTuff]

My seats have original saxo subframes welded on... so i got the standard bolt hole from the original seatbelt for me to screw in an eyebolt :y:

mine are on xsi standard subframes so ill do that for now, but im gonna make some sub frames as i feel the seat is a bout 2 inches to high for me

Drill a hole in the tunnel and put spreader plates in by the exhaust for the eyebolt to thread into
Its the only safe way

ive been looking at these plates and was gonna mount 2 plated on the tunnel and weld them on, that an ok place to mount them?

i have mine bolted to rear seat belt clip in the middle then the right bolted to the bottom where standard belt bar was and the left onto the floor where seat mounts but i have just bought a eyelet kit which will be fitted in the near future.

ah ok im gonna do the same for the right side and the rear

:hug: saxp love

[manta]

I've got a 3 point harness in atm, just to get it through the MOT. 6 points will be sorted after.

The lap belt is mounted to the seatbelt bolt by the door and the other end is mounted to my custom subframes from Ben on here.

The shoulder belts are mounted to the C pillar, prevents spine damage.

[GTuff]

I've got a 3 point harness in atm, just to get it through the MOT. 6 points will be sorted after.

The lap belt is mounted to the seatbelt bolt by the door and the other end is mounted to my custom subframes from Ben on here.

The shoulder belts are mounted to the C pillar, prevents spine damage.

is it really that bad if i mounted them where the rear seatbelt plug goes?

[AlexB]

Welding plates to the tunnel is fine

Id weld them to the underside of the car personally so it has to pull through which is impossible to come free but have seen it done on top

Mine werent welded but passed an mot

[MR_N]

I have spreader plates welded on top. They have a thread in them, also have a nut on the underside of the car just incase.

[GTuff]

nice im keeping my carpet in wud like a gold eyelet jus poking through lol