wishbone rear bush diameter

[clen666]

Hi all,

I ordered a pair of motaquip wishbone rear bushes of Ebay but I was sent two different bushes.
One has a ~13.6mm hole and one has a ~16.8mm hole, can anyone tell me which one is required for vtr/s wishbones please?

Cheers

[clen666]

Anyone?

Really need to get the wrong bush swapped and can't get under the car until the weekend

[axsaxoman]

I am guessing you have been sent one bush for front of arm and 1 bush for rear of arm

[clen666]

I don't think so as both bushes are more or less the same, and had the same part number on the box:
http://i427.photobucket.com/albums/pp355/clen666/IMAG0288_zps092548bc.jpg

No one have a spare wishbone/bush to hand that they could measure please?

[axsaxoman]

you can replace one side ansd then you will know which is the right size--but my guess is it is the larger one the other one is from an early AX ehre the rear pin screwed into the arm and later type is cast as part of arm
make sure you fit it in correct orintation
IE the mouning plate fits flush when arm is at normal height WHEN CAR IS ON THE GROUND
other wsie you will stress the bush

[tillygti6]

Top one is the one you need. the bottom one, even if it fitted the arm wont clear the anti roll bar.

[clen666]

Great, thanks for the advice.

Have emailed the seller about a replacement.

:)