problem after head gasket change

[borders]

just done mine and it wont start, but is has been over 2 weekends, result all back in one piece and no bits left over. could i have made a mistake with crank sensor? where is it / colour. everything seems and sounds fine but not firing.

will i get a spark if crank sensor fault

just checked i have a spark, sounds loads better, fuel coming through, when cranking after a 10 second burst i get a pop.

[Gandi699]

timing out?

[borders]

i commented on a different thread, when the head went to be skimmed i left cam pulley in place, engineer removed and whilst cracking nut the pulley and of course cam turned, when put pulley back on it went from say 1 oclock (locked position ) to 11 oclock, i followed advice and just turned it back to the 1oclock position, could this be 180 out as when fitting belt crank and cam were aligned.

[Ross]

Split this into it's own thread so it's not clogging up the guide.

Cheers