Piper Exhaust Fitting

[Yop]

Hi, just fitted a Piper exhaust today ( Back box only ) and it isn't fitting very well. It sits low and to the left. I've tried moving it about on the hangers but not a great deal happens. Anyone have any ideas what I could try ?

[stevo67]

Try bending the hangers or put cable ties onto to it to pull it over a tad.

[marcusd]

if its hanging lower than bumper its for a 106? I have a piper and its on standard hangers (uprated ones) and sits dead centre and with a 20mm gap all round the cut out.

[Yop]

It doesn't hang lower than the bumper, the standard hangers do seems to stretch down a bit with the exhaust on. I might try to get uprated ones to make it sit a bit higher. Did yours help ?

[m4tt274]

it needs a male/male adaptor. fit that between the mid pipe and back box, slacken it, pivot it up then tighten it where its correct..

[marcusd]

even with standard hangers it hung perfect, just uprated em cos my standards snapped

[Yop]

Ill give that a go, see what happens. Cheers

Ah right thought with them being a bit stiffer it might of held it abit higher.