lost locking wheel nut key!

[Reecesaxo]

so i have lost my key to get my locking wheel nut what is the best way to remove them? how much will it cost at a garage?

[GTuff]

Depending on what type of clocking wheel nut it is get a socket that's just too small and a hammer hammer it on then come off easy go on youtube loads of vids

[Reecesaxo]

pretty sure its a standard saxo that originally came with the car

[boarer2004]

Take it to a decent garage and they will have loads prob charge you £10 pounds

[GTuff]

pretty sure its a standard saxo that originally came with the car

yea jus bang a socket over it easy

Take it to a decent garage and they will have loads prob charge you £10 pounds

not open on sundays though....

[9mm]

http://www.youtube.com/watch?v=GFXfEhTi8VU
THERE YOU ARE

[Mcgawn]

Easyouts are what u need

[boarer2004]

yea jus bang a socket over it easy



not open on sundays though....
Wait till Monday !!!

[GTuff]

Wait till Monday !!!

i have the patience of a kid cant wait for anything to do with impeding me to drive the car lol

[citroensaxo]

Dear Reecesaxo,
Ditto what GT says really, ( depending on which type of locking key is fitted to your car, ie the type with three prongs or the type that have a collar that spins around ) You will need to use a single hex impact socket, size smaller than the locking wheel nuts and bash them on with a hammer.
I hope this helps,
Vince,

[Reecesaxo]

It's got four pins, do i need to hammer the socket around the perimeter of the whole bolt e.g. the bit in between the wheel and bolt or the smaller bit which sticks out which i think is approx 12mm thanks

[stevo67]

Around the perimeter then put a breaker bar on the socket mate.