Bit of help guy? 306 to 106?

[shannon-ob]

Hey guys!

Been a long time since I posted.

Anywho, I'm picking up an S2 rallye later tonight :) It's running standard 247mm calipers. However, my friend has his old 306 D-Turbo sat outside my unit ready to scrap, and says I can have anything I want off it! From my understanding the front calipers are 266mm? Good news for me, however will the master cylinder also fit on the 106?

Lastly, is there anything else on this you would consider me to keep as spares or upgarde?

Shannon.

[Mickswan]

You'll have two port and four port master cylinders.

I'm assuming the S2 will be 4 port non ABS and the 306 will have ABS so be 2 port. You can use the M/C but will need a T piece fitted.

IMO your better off with a 4 Port 23mm M/C

[shannon-ob]

Okay, cheers. I'll check this tomorrow to be sure!

Is there anything else on these that fit a 106?

[KamRacing]

make sure you get the pads to make your life a lot easier when identifying what caliper you have for future spare parts.

[Alfie09]

Keep the reg number of the 306 as that will help pads in later days

[shannon-ob]

Yeah I was going to do this! Just wanted to know if there's anything else that's a straight swap/upgrade :)


Sent from my iPhone using Tapatalk

[welshpug]

DTurbo will have the same ATE 247mm brakes as a saxo, unless it has ABS.

[shannon-ob]

I typed the Reg into ECP and said it was 266?

[Mickswan]

make sure you get the pads to make your life a lot easier when identifying what caliper you have for future spare parts.

Amen..