Fitting Amplifier problems

[Dexter1]

Hi there! Hope you can help me out as I am sure many of you have been in a similar spot. I am trying to locate a position where I can feed an amplification wire from the car battery through to the foot well. So far the areas I have found seem quite tricky to get to. What is the best and easiest method?

[klass-adj]

if you open the bonnet of your car just under where you put brake fluid there is a grommet that's where you go through but you might have a small battle on your hands. firstly you'll have to get through the fire wall to make a hole to the back of the dash board i used a long flat headed screwdriver to do this , now after you've done that get some washing up liquid and put on the cable not much just enough to help you push you amp cable through the grommet till you think you have enough through then go back to the car and find it ,its a ball ache but it'll work i think there is a post with instructions in this forum somewhere

i hope this helps

[stevo67]

http://www.saxperience.com/forum/showthread.php?t=62418

[AdamB2904]

if you open the bonnet of your car just under where you put brake fluid there is a grommet that's where you go through but you might have a small battle on your hands. firstly you'll have to get through the fire wall to make a hole to the back of the dash board i used a long flat headed screwdriver to do this , now after you've done that get some washing up liquid and put on the cable not much just enough to help you push you amp cable through the grommet till you think you have enough through then go back to the car and find it ,its a ball ache but it'll work i think there is a post with instructions in this forum somewhere

i hope this helps

Its much easier from inside the car. The grommet is just behind the glove box, just whip that out. Not sure about saxo, but in my quiky its just 2 white pins that hold it in at the bottom.