Lowering torsion bars weird problem

[LukasGTi]

Hi, guys i need advice please. Today I was lowering rear beam and i am not able to match same height on both sides because of this (PICTURES)... While it s on one side on hole on the other is not. And when I tighten bolts up it results in differents heights. I spent all afternoon doing this a now i don t know if am just stupid or there is some kind of problem. Thanks for any help!

http://s8.postimg.org/rv54h8ef9/IMG_0001.jpg
http://s29.postimg.org/mfzqi5zl3/IMG_0002.jpg
http://s23.postimg.org/vblj3p9kb/IMG_0003.jpg

[stevo67]

Before we go any further,why is the car not on axles stands?

[LukasGTi]

Because poor student life

[VeiRoN]

Please use some axle stands,the end plate spines are not aligned,take it out and fit in the same position of the driver side.

[Ben_SaxoForte]

Nice tree trunks, but yeah be careful don't want a car on you! how are you measuring the height of the beam by the way ? my guess is someone has had the anti roll bar end plate off before and not put it back straight

[LukasGTi]

I will spent i little money on axle stands. :)

anyway, problem solved, but there is another.. I am not able to fit 2 washers back in. One one every side. I double check if the bars are fitted properly and they are. Don t really know what to do..

[VeiRoN]

Should have taken note of the old washers position,they should go back in the same way as before they came off if I'm not mistaken.

[LukasGTi]

I thought that they are all the same...

[VeiRoN]

They are all the same but they go back in different positions on each side,which side exactly are you having problems with? I could take some pictures for you on how mine sits if that's any help.