Rockercover gasket?

[Vinootje]

So my rocker cover needs a repaint and under the rubber there is a little pool of oil.

Its a 1600 8v block in a phase 1 saxo from 99.

So when i am going to repaint the rocker cover i want to replace my rocker cover gasket. I can only find this style of gasket which goes around the block right?
https://i.ebayimg.com/00/s/NDUwWDYwMA==/z/5AQAAOSwYIxX2tjr/$_58.JPG

[sri_130]

Instant gasket / gasket sealer matey

[welshpug]

Instant gasket / gasket sealer matey


captain bodge!


just fit a new gasket.

[Vinootje]

captain bodge!


just fit a new gasket.

well i linked one and i have a feeling this one is wrong.

Instant gasket / gasket sealer matey
U mean liquid gasket?

The one i sended in the link isn't the right one, right?

[axsaxoman]

a new gasket would be good --but most likely problem is that where cover bolts down over tightening has depressed where the nuts fit ,and so now it will not put enough pressure on gasket
remove cover hammer the fixings holes back up and then refit
should be spacers in there ,but these get lost and then cover bends when it is tightened down

same used to happen to old bmc engines like the "a+B" series --cure was the same straigthen cover

[Vinootje]

a new gasket would be good --but most likely problem is that where cover bolts down over tightening has depressed where the nuts fit ,and so now it will not put enough pressure on gasket
remove cover hammer the fixings holes back up and then refit
should be spacers in there ,but these get lost and then cover bends when it is tightened down

same used to happen to old bmc engines like the "a+B" series --cure was the same straigthen cover

Thanks but what if i lost the spaces? how to recover it

[welshpug]

find spacers, or make spacers.

[Vinootje]

find spacers, or make spacers.

How do these spacers look like?
Not regular washers?

[welshpug]

part number 020543, pieces of tube, plastic I think.

[axsaxoman]

you can even bend cover if you get spacers in wrong place

should be deflector plate on first --then spacers -NOT drop spacers on studs ,then fit plate and drop cover on top
that will cause bend in cover