Help fitting Buckets/Harness

[VTS_16v_Boy]

Can anyone who's fitted Buckets in their Saxo's give me abit of info. :P

I've already got my Bucket, Runners and Subframe (All Momo), this is not where the problem is.

Wats the score with the harness? does the side that replaces the buckle that was on the OE seat bolt to the subframe? as I know the other side goes to the base of the seat beat bolted to the side of the car and the rear bolt to the rear seatbelt mounting.

Ive fitted harnesses B4 but never to a car where the was no centre mounting.

Any and all help is greatfully accepted :clapping: thanks guys

[VTS_16v_Boy]

Plus can anyone tell me wats the offical score with Harnesses in a Saxo when it comes to MoT time? as the oringinal seatbelt can not be used while the Bucket is in place of the OE seat.

In the past I have been able to leave the OE Seatbelts+Mountings in the car but this is not the case with the Saxo.

Thanks Guys

[Recovery]

Are you getting rid of your back seats?

[hesslevtr]

i used the mounting point on the subframe, the mounting point where the belt goes right at the bottom and used the rear seabelt i had to take a buckle out though

regarding the OE buckle i could of used both on my frame but chose only to use harness and out the OE buckle back in for MOT i also needed to put the rear buckles back in to

i used cobra frames so will probley be diffrent

[VTS_16v_Boy]

Ok, Thanks

I haven't got my harness yet so its still alittle unclear. Ive got a MoT at the end of October so I'll wait untill after the Mot to start mucking about with it.

I spent ages lookin through loads of lod mags at home looking to see if I could see how they fitted and looked in a few Saxo's at Trax this year but without sittin in its hard to see. Plus if the subframes vary what one person says may work for them but not for me and others.

Cheers anyway :clapping: