Audison SRX2 Arrived, BUT -- HELP lol

[Salmon1]

Well It FINALLY arrived, but i have a new dilema.

I am Running Boston S50 Components of this amplifier, the components are fully wired up with the Crossovers in the door cards.

It says "2 channel Amplifier with Crossover"

Then It has "Speakers In" With L + R Terminals (4 in Total, 2 negative, 1 positive). This Sections Also has a Dial with "Level.2-5v") What is this dial?

It also has a "Speakers Out" Section With L+R Terminals (4 in total again)


Theres is then a Bit called "Filters" which controls Frequency, It can be Set to HI-Pass, Full, LO-Pass. Which Should i set it to?


Thanks

[Salmon1]

Right ive figured out that i just ignore the "SPEAKERS IN"

But what do i set the following to-

Frequency (between 50-220Hz)?

Hi-Pass Or Full Or Lo-Pass?

[l1ukeRS]

hi pass is what you want i think, low is for bass

play round with the frequency till it sounds right

you got any pics of your finished build yet? ill be finished before you at this rate an im doin fiberglass

[mehmeh]

Stick the crossover on full range.

If the speakers distort (they shouldn't unless you've not set the gain properly or they are mismatched on power) then change it to high pass and set the frequency to around 80Hz

[flee123]

you want them on full mate

[chloesax]

hi-pass is like really really high on the frequency bandwidth.

go full.