supersprint centre section

[chrisni1986]

went to fit my centre section today and when i go to bolt the centre back up to the manifold the bolt goes straight thru the bracket holes in the centre pipe as there too big for the bolts, has anyone else had this problem and if so how did you overcome it?

Cheers

[Banger_VTR]

there shuld be lil washes i think that go on the bolt, then the spring, then another washer then the nut the hole is like that for the spring to sit in

[Mystic]

There will be 2 plug/washers, as mentioned, stuck in the section you have removed, pop them out and put them in your supersprint one. :thumbup:

[chrisni1986]

sorted cheers!

[Banger_VTR]

whats the supersprit one like mate, is it for a vtr, im lookin to get one.

[chrisni1986]

its still blowing out slightly so ive got some sealer to put round it, nice fit and looks the business, my mate had one on his vts and it helped loads!

[Mystic]

blowing from where? Theres a metal mesh thing that should be in that join where you just put the plugs in for the bolts. U might need a new one if its blowing from there?

[Banger_VTR]

yeah it slips on the new center bit u could of missed it or damaged it when puttin it on

[chrisni1986]

its blowing from where the centre section bolts onto the backbox, pain in the ass to get a good seal!

[Banger_VTR]

it is like every time ive dun a saxo exhaust it always leaks from there

[chrisni1986]

got the leakin sorted with some gun gum, car flashed up the engine management light today but its still driving fine and pulling well etc, all i did was change the centre section, any ideas why this would be? i didnt start the car until the lamda sensor was back in underneath the car