PDA

View Full Version : fitting harnesses. 3 point


spencer_cammedvts
8th December 2006, 13:42
iv just fitted my 3 point harnesses but iv just slid the original belt buckle under the seat because i know that if i unplug the seatbelt pre-tensioners my airbag will go off. how do i get round this?

spencer_cammedvts
8th December 2006, 14:09
:bump:

Scott
8th December 2006, 14:26
easiest way is what you haev done, just cable tie the tensioners to the boot of the seat out of the way

spencer_cammedvts
8th December 2006, 15:00
Its Still Got All The Seat Belt Buckle On It Though! I Know When I Fitted My Buckets I Disconnected The Battery So That The Airbag Didnt Go Off. I I Did This Then Disconnected Them Would The Airbag Go Off When I Connect The Battery Back Up?

hesslevtr
8th December 2006, 15:49
dont think you can take the buckle off the tensioner anway well not without destroying it i tie rapped mine underneath my seat and was fine

make sure the batterys disconected when disconecting and conecting them just incase

Scott
8th December 2006, 15:50
i have never unplugged the battery when moving seats or airbags or even taking the steering wheel off, i just dont want to lose all my EQ setting son the headunit though:P

hesslevtr
8th December 2006, 15:52
i have never unplugged the battery when moving seats or airbags or even taking the steering wheel off, i just dont want to lose all my EQ setting son the headunit though:P

same here

dont because of stero i always forget :panic:

stevossaxo
8th December 2006, 16:46
i have never unplugged the battery when moving seats or airbags or even taking the steering wheel off, i just dont want to lose all my EQ setting son the headunit though:P

same lol i like the risk factor :panic:

Ax_beefy
9th December 2006, 02:28
Air bag shouldn't go off!... only if the tensioners are activated by the airbag controller!.... we just snipped ste's off lol... then had to wire them back up.... doh!