headlight adjuster motor removal

[Steve]

how do you get it out? need it out to fit to my black headlights! :y:

i think i just need to pull but not went full heart into it incase i break something....

rep awaits :afro:

EDIT its not the wire its the actual unit i need to take out the back of the headlights!

[Steve]

twisted them and its come loose now is it just pull hard as they are clipped inside?

[Mark51]

they are held in with like a ball on the end of the stick that fits in between two pics of plastic.

they just pull out. or you can take your headlight out and slide the motor up or down and it just pops out of the two bits of plastic

[Steve]

yeah done it mate got them fitted now, cheers though. al get some pics up!

[Steve]

The Pictures (http://www.saxperience.com/forum/showthread.php?p=847650#post847650)

[Predator_R32]

did you find it easy to get them back in then :)

[DevilDamo]

I had a few problems when I did mine so I got Citroen to do it :) Hehe!

They can be a fiddly bit of equipment to remove.

[Predator_R32]

the way i did it was to get my finger in were the actual headlight bulb goes and lift the insert (reflector) up to get the clip right up to the hole, this made it easy to put the ball joint thing on the motor back in

[DevilDamo]

Yep... that is one way. It sometimes just comes out by fiddling it.

[Predator_R32]

thats the way i got it back in lol, the way i got it out was by twisting and pulling and swearing :)

[Steve]

i had the glass off my headlights so was a piece of piss to get them back in, but my mate had to do his with the glass on, had to push his finger in for it to clip on

[DevilDamo]

The glass off!?! :-S Well, that's different and definitely not the way I would have recommended.

[saunders]

iv gotta admitt i had to use brute force to get mine back in! there a bitch to do

[Steve]

The glass off!?! :-S Well, that's different and definitely not the way I would have recommended.

i had them apart to spray black!