5 inch in the dimma rear bumper?

[vtsturbo]

http://www.sax-p.com/photos/photo1473.jpg

does it just fit or is a slight bit of cutting needed to fit the pipe in?

[barrett]

looks like theres been a bit of cutting but i'm not sure

[Scott]

ask the bummer himselfsmileys/smiley17.gif

[dannsax]

if you look just under the pipe you can tell there has been some cutting

[liamhewitt]

take about an inch off, will look good to

[Simo]

A little bit of cutting to stop it rubbing when the engine swings... not much needed really though.

Pre-cutting (just about see)

http://www.sax-p.com/photos/photo1316.jpg

[Propagand]

A little bit of cutting to stop it rubbing when the engine swings... not much needed really though.

Pre-cutting (just about see)

http://www.sax-p.com/photos/photo1316.jpg
Does those dimma bumpers fit on 1.1i bumper?

[barrett]

think it would fit but it may look a bit funny on the sides where it should meet the wheel arch... You would probably have to buy the VTR wheel archs and get them fitted aswell

[Scott]

i dont think it will fit as the dimma bumper is moulded to go around the bum strips on the VT models, it is not a whole bumper but a skin you attach onto the origional bumper