Is my clutch up the swanney?

[oz_borne]

Right, not ragging it but you know, going at a fair old pace, in third doing 3000 revs then accelerating, my engine sounds like i've gone and put my clutch down a little bit. But i haven't.

It doesn't slip when teh handbrakes on and in gear, only when i'm going at it and driving.

HELP ME!!!!!!!! I DON@T WANT TO SPEND ALOT MORE ON DON THIS MONTH!!!!!

SCOTT HELP ME

oz
smileys/smiley14.gif

[Scott]

Stick the car in fourth and lift the clutch, if it stalls pretty much instantly the clutch is fine, if it contiunes to run for a few seconds or doesnt stall at all the clutch is fucked.

Other than that, any engine mods?

[oz_borne]

only induction kit. It does stall in any gear so that sounds as if it is ok! But why does it rev when going i don't get it!!!

smileys/smiley14.gif

[barrett]

in too high a gear maybe? smileys/smiley5.gif

[Scott]

induction kit sooking in plenty of hot air i may guess

[oz_borne]

yeah it is, we spoke about that before. Does that fuck it oop then?
smileys/smiley14.gif

[barrett]

yeah needs cold air for better combustion or something

[Scott]

its certainly not doing it any good.

Personally if you cannot make your own decent cold air feed or DIY enclose it i would take it off

[oz_borne]

Right weekend mission, tin foil and an extended pipe are a must!!!!!
smileys/smiley14.gif

[Smithy]

I had same prob with my vts. had a piperx induction on it an it was awful. Lost power and revs were weird. Changed to a green enclosed an its much better.