i got problems

[liam_b]

1: how do i remove the glove box in a 1.1sx i have remove 4 torx screws but theres loads of wires and i think theres somethink else holding it but dont know what any one know?


2: well i was trying to take out my front passenger seat and i was using torx 30 bit witch i thought(sp) was a torq 40 and i have rounded the blot off :n: now when i try using a torq 40 bit it grips a little bit then slips what can i do to get the bolt out? i was thinking about gluing the bit on to the bolt but dont think it will hold as the bolt is relly tight


how have you lot got the amp power cable thru the Grommet behind the dash as theres know room to move and i cant get it thru any tips? and has anyone ran a 0 awg cable thru there car is it easy?

[riggsy]

I stuck a screw driver through the grommit to make a hole and poke the cable through dude!

As for the bolt you have rounded off either get some one to drill it out, or use something to make a line across the head so you can use a flat head and twist it out.....

Not sure on the glove box never taken it out? Keep searching might be another bolt your not finding?

[liam_b]

well 5 cuts later 2 broken mugs and i have one amp wire thru i stuck a screw driver through the grommit wire still wouldnt go through put a small wire through tide it to amp cable but the wire broke so trid somint metal cable and that broke in the end i drilled it thats one problem try'd geting glove box out toke out all 6 screws and a metal plate but still woludnt come out so left it and screwed it back in dont need it out now any way so one problem left front passenger seat any one got any advice?

reped riggs

[melly]

like riggsy said make the head of the torques bolt into a flat head , ie run a small haksaw blade across it allowing u to use a flat headed screw driver to get it out, other wise drill it out mate simple fix just take ur time