lower grill

[B+B]

Hi, just a quick question, is the lower grill on the mk2 (furio) part of the bumper? or can it be removed without removing the bumper. as I want to mesh the lower grill.

http://i175.photobucket.com/albums/w139/beltand/DSCF0002-4.jpg

[Robbo]

its part of the bumper fella! you need to hacksaw it out. if you look close and feel it you can see its all one part.

[Robbo]

oh and it will make it alot easier to take the bumper off to mesh it as you can see what your doing and stick the mesh on properly :)

[craig180]

There are black plastic slats behind the lower grill which you can remove and replace with mesh, or you could cut out the whole lower grill and mesh that (like a big mouth conversion)!

[B+B]

oh and it will make it alot easier to take the bumper off to mesh it as you can see what your doing and stick the mesh on properly :)

bit like you do the bonnet mesh, remove it and cut the slats?

[Robbo]

are you talking about the WHOLE of the lower grille, like the one bar the goes across and the 5 that go vertical or just putting mesh behind whats already there? im confused lol

[B+B]

[QUOTE=Robbo;1003296]are you talking about the WHOLE of the lower grille, like the one bar the goes across and the 5 that go vertical or just putting mesh behind whats already there? im confused lol[/QUOTE

remove the left to right bar and the 5 drops, then mesh it.

[Robbo]

yeh it will be easier then to take the bumper off, that way you can see what your doing properly and youll know where your gluing the mesh

[B+B]

Thanks Robbo,
(rep on way)

[coldo1987]

a bit like so?

http://i159.photobucket.com/albums/t132/coldo1987/front.jpg

[B+B]

a bit like so?

http://i159.photobucket.com/albums/t132/coldo1987/front.jpg

Spot on!!! was it akward to do? can you give any tips,:clapping:

[coldo1987]

Spot on!!! was it akward to do? can you give any tips,:clapping:

wasnt that badactually all i did was remover the bumper and i used a hacksaw blade to cut the horizontal slat off at each end then all the vertical ones then it came off easy in one piece.after that it was just a case of tidying the bumper up a bit and placing the mesh over the space and bonding it.think i used silicon on mines and left it to dry

[B+B]

Thanks for all your help coldo1987
(rep on way)

[Adum]

There is a guide on here that tells you how to do it. Enjoy: :y:

http://www.saxperience.com/mods/how-to.php?page=2

[B+B]

Thanks for all your help, I'll give it a try friday.