black badges

[blacksax1]

how do i make my saxo and citreon badge black? can i do it with them on the car or do i have to to take them off to do it? if so how do i take them off?:y:

[lottaroo]

Think you can just T cut them, plently of elbow grease needed mind!

[al_VTR]

much easier to take them off mate. heat up the badges slightly using hair dryer/heat gun - this'll loosen the glue. then just SLOWLY pull them off, its a good idea to push using the pegs inside the boot as well

then you just rub them down, paint them & lawuer if you want.

[blacksax1]

sweet can you really t-cut them as that would be good as i am working outside and no plugs or nothing so a bit of a pain to get everything outside

[Aron]

yer prob easier to take them off just be carefull not to break them but just t-cut them which is easier. Takes a bit of time and elbow work but is worth it.

[Predator_R32]

good old search button is magic :p has been asked so many times :)

[adam111]

I used some chrome polish made by he same people who make T Cut and it came off fairly easily.

[Delboy75]

I used T-cut and didn't remove the badges.
20mins is all it took, gotta rub quite hard but the finish was good.

Use the original T-cut, not coloured.

[Predator_R32]

ive just done a guide so check out the FAQs :y:

[VTS_16v_Boy]

Good old wet'n'dry sandpaper, watch out for the blisters on the fingers!

The top coat of Silver should come off and leave just the black, might be worth just using a tad of Tcut once the silver has all gone to get a slightly nicer finish to the Black :y: