How Low Can I Go [Archive] - Saxperience

jaybiss

27th July 2004, 21:10

1.1 3dr saxo

15inch alloys

How low can i go because i herd dat the drive shaft breaks at 50mm but then some peeps where sayin 40mm is the limit

jamesg88

27th July 2004, 21:33

i would recommend a 40 mill drop smileys/smiley4.gif

Scott

28th July 2004, 02:35

the shafts wont just break if you lower it 50mm but it will start to put them under a lot more stress due to workign at an angle

GreenSaxo

28th July 2004, 04:13

45 at the front.. 85 at the back smileys/smiley4.gif

some pics of my 1.1 smileys/happy.gif

http://www.sax-p.net/upload/gs_june04/2.JPG

http://www.sax-p.net/upload/gs_june04/1.JPG

http://www.sax-p.com/members/GreenSaxo/ACA_March04-1.JPG

http://www.sax-p.com/members/GreenSaxo/488_March04-2.JPG

(any excuse to post pics smileys/smiley17.gif )

Dan

28th July 2004, 04:23

like what has been said earlier dnt go lower than 50mm as the driveshafts do sit at an awkward angle.ive had problems with my driveshafts a mnth or so ago!mines been lowered 60mm all rnd!

jamesg88

28th July 2004, 04:51

i am going for a 40 mill drop on mine with 16's smileys/smiley2.gif