Urgent Help Required Asap

[ollyboy_saxo]

Hi all, right the problem, ive just re-sprayed the backgrounds in my headlights and re-sealed them air tight after wards but i seem to be getting the lenses full of moisture and they're really bugging me, anyone had this problem when doing there own , any advice welcomed as i dont want to have to splash out on some new headlights
cheers guys
oll

[Jungle_Jim]

this is either because you havent sealed them properly or you didnt let the dryout when you sealed them, you should have left them at room temperature for a couple of day before adding the sealant to make sure no moisture was trapped in the light.
you wont need new lights, just open them up again and reseal them

[furioAL]

No need to open them up again... apply some mastik type sealant around the edge of the light join... this will make them air/water tight...

Then use a hair dryer in the back of the headlight (where the bulb is) this will heat up the moisture... and it will clear, then refit the lights and make sure you apply the rubber seal back behind the headlight bulbs :y: Then you should be ok!

Hope that helps!
Alex
:)

[ollyboy_saxo]

cheers for advice both of you going to try als first though , thanks fellas