Fitting 106 doorcards

[azzy]

As above really. I took my vtr ones of & the were clips but i know the 106 cards have the little screws.

Hows the best way of fitting them.

Thanks chris

[rob_s]

mine dint have screws :S only where the handel etc was they just pull off same as saxo ones bar screw that holds the door bin/handle on

the only thing you will have to do to get them to fit a saxo is (i think never actuly done it)

remove the bracked that sticks out that would hold the saxo one on where the handle recess is

there mite be screw holes in the right place already for the 106 handel etc
ig there is its a piece of piss just a simple swap over job


i would make you a guide or summet but tbf i dont fancy pulling both 106 and the saxo apart in this weather :lol:

but plenty of ppl will have done it so someone can prolby 100% tell you ;)

[steviet]

ave just put the 106 doorcards on my vtr. i didn`t use the popper clips to put them on the, screws like you say. i just hooked the card on at the top and drilled all the holes along the bottom. then i put the door handle on and that was the nightmare part getting a long enough drill bit. screw the door handle in place then clip the centre part onto it then clip the side pocket on to. then screw all the hole you drilled along the bottom

[azzy]

Cheers guys. At the mo one is saying its easy & one saying its kinda not lol. I will wait till its better weather to mess around.

[steviet]

Cheers guys. At the mo one is saying its easy & one saying its kinda not lol. I will wait till its better weather to mess around.

it is easy just a wee bit nippy at the door handle part cause you have to drill at an angle and its getting the screw in thats the nippy bit. forgot to say your saxo mirror plate will also be way to short so you`ll need the 106 ones.