106 help poss same as vts

[kevvts]

After recently purchasing a std airbox set up i started to remove the induction kit that was fitted, but there's a pas pipe in the way and it forces the std air box cold air feed tightly against the radiator.

here's a couple of pics of the pipe in the way

http://i2.photobucket.com/albums/y5/st24v6/misc/p0078.jpg

http://i2.photobucket.com/albums/y5/st24v6/misc/p0057.jpg

Can anyone verify if these pipes are sitting the right way compared to your own set up and if not which way should they be ?

And as for removing pas pipes from the pump to re-route them does the system then need bled and if so is it hard to do ? all help appreciated ;)

[ad_vts]

Just a tight fit mate, you should be able to move the pas pipe enough to fit the air intake down there, and yes the pas system will need to be bled but is not to hard

[kevvts]

The metal pas pipe is solid no movement at all

how do you bleed the system as the only way to sort it is loosen the bolt on the top of the pump to move the metal pipe to opposite side of two rubber ones