PDA

View Full Version : amp remote cable..

s3tre2003
28th July 2007, 16:40
is it safe to run another cable of this to the inside of the sub box to power some tiny LED's?..
Predator_R32
28th July 2007, 16:44
why dont you wire the leds up to the boot light mate or the boot light switch, bot the same tbh

this way they would only come on with the boot open and last a lot longer :y:
s3tre2003
28th July 2007, 16:53
theres one light wired to that already.. you rekon it would be safe to bridge more off it?
Predator_R32
28th July 2007, 17:00
is there an inline fuse to it mate??

i dont see why not, leds dont draw that much power
s3tre2003
28th July 2007, 17:03
no.. was told its safe because its using the fuse in the fuse box?
Predator_R32
28th July 2007, 17:07
no mate should still have a fuse on it
s3tre2003
28th July 2007, 17:09
thatl be the next job then.. with the fuse you rekon it would be safe?
Predator_R32
28th July 2007, 17:14
does the led have a adaptor that has some info on the back of the voltage etc??

id use the same fuse as what the boot light is on, so a 20 amp :y:

fuse holders are cheap enough too and could just save your car from a fire
s3tre2003
28th July 2007, 17:21
na the leds are just ona a wire.. nothing else
Predator_R32
28th July 2007, 17:23
get a fuse on mate for sure it might be ok from the wire from the fusebox but if theres a fault from the bootligh/switch then it will bugger up the leds
s3tre2003
28th July 2007, 17:29
yh ill wack one in got a spare here somewhere..thanks pred