wheres you all run your live through?

[garry_k]

where has everyone run their live through the bulkhead? through the big grommit or bored a new hole?.. im running 2 4 guage by the way, and theres a big live coming through the main grommit as it is.. dont wanna run too much through the same place lol

also where is a good earthing point in a saxo?

[super_cds]

i drilled a new hole for mine then put a grommit in!
was on the pass side, behind the glove box (after taking it out) to the far left side.
for the ground at the back, try the middle bolt where rear bench is on, may have to send the paint off, to get a better connection!

[Baz]

why two 4 guage and not just one 0 guage through the grommit under the brake servo?

[pat_man_vts]

defo use the existing gromit, will be tight but just pull it through.

as for the earth, i used an existing earth behind the rear doorcard the first time i did it, now tho im using one of the bolts which used to hold the rear seats in, anywhere paint free and secure will be good

[Predator_R32]

have a read of the stickies mate, dont run 2 from the battery either use a distribution block :y:

[garry_k]

im running one zero into the distrubution block, but im keeping it at the front of the car, dont want to clutter up the boot too much with electrics..

cheers for help folks, i used one of the latch bolts in the boot for my earth, seems strong enough..

now for my false floor :)

[RS_Matt]

lol I have 2, major cock up as I've upgraded to a bigger amp and wish I'd just stuck a fat load through so I can swap and change amps at will off a distribution block.

[Predator_R32]

although the boot latch will probablies be ok for an earth i still think under the seat bracket is best, but thats my opinion