![]() |
After having a few problems fitting the throttle bodies and it spitting flames out of the inlet,it finally works!
I wired in the Throttle Pot earlier, and it started first time. Its no where near finished,the throttle cable still needs attaching,the wiring needs doing properly and the fuel lines need cutting to make it tidier. But the main point is it works! And the noise is amazing. The only problem is that it is running lean at the moment,but my kms always ran lean until it warmed up so need to try it properly and then off to mapping! |
sounds good man :D
need to see this thing now |
Heres some pictures from the past few days:
I was stood like this for hours: ![]() Attacting the car with a file: ![]() The state of the engine bay as it stands: ![]() The bodies fitted,but without the trumpets at the minute: ![]() |
looks good mate
|
Wish there was that much room in a 106's bay :(
|
Parp!
nice update. |
what bodies are you using?
looking good mate :y: andy |
Quote:
|
Well its died again,When tidying everything up we tried to connect the throttlepot to the loom properly. And since disconnecting it and trying it again it wont work and the KMS shows a reading of good old 22.1
Im just hoping its because the connection to the pot isnt very good so trying it again tommorrow but I dont have any hope. It is also booked in for mapping next friday but I am unsure if it will make it. I am gutted tbh. |
dont give up now shes so close :P
|
Quote:
thought you was looking into AT power throttle bodies? Quote:
where is meant to be going for the mapping? andy |
It's going mikeanics for mapping as it's not too far from me.
I already had the jenveys,I just really liked the look of the atpower bodies and how simple theyare to fit.it would have saved me some problems. |
Nice car and indeed quality mods you have on it, dont give up on it with the final stretch being so close m8e :y:
Mikeanics is a quality mapper and your in safe hands with him, look forward to you results pal :y: ManC |
Quote:
|
nice stuff dan shame its dead again mate :D keep up the good work dude.
|
Quote:
|
Quote:
anyway hope you sort out the problems :y: andy |
keep fighting mate. you will get there man!
|
Well iv been trying all day and no luck.I have disconnected the lambda as I was advised to do and no luck. I
I think its RIP Saxo. I have taken the plugs out and left the cylinders to air incase its flooded the engine. |
I hope its not RIP saxo...its gorgeous.
Would love to tb my vts! |
All times are GMT. The time now is 07:37. |
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.