Stop guessing, get on servicebox!

Im going to be ordering my BE hubs which i'll be buying new. I need to know the lenght i need to machine them at 37mm. My old hubs are still on the struts and the car will be getting moved shortly so cant check them.

Does anyone know the lenght the BE hubs need to be machined at 37mm OD?

Same as MA. Just send one with the hubs and machine to same dims.

I will be machining them but dont have any MA hubs spare, i want them done so can get MA ones removed and BE fitted at the same time.

This is the boat I'm in also, may pay you to get a strut so you can work it out.

Nice work

Coming to doing my hubs, i was going to machine them too 33mm lenght x 37mm OD as this is the dimensions of the wheel bearing and use a 3mm spacer for the offset.

Or does the hub need to be machined so the back face/flange is flush but there is 2 faces on the back of the hub which are 34mm and 36mm in lenght. Guessing it will be the smaller one in diameter to be machined too but either way its going to be 33-34mm lenght.

If i dont find out this anwser i will just wait until i have my MA hubs off and use old bearing and the MA hub to go off so i get the right offset, etc.

The spacer dimension i will be making them too will be 37.1mm ID x 51mm OD x 3mm Width for anyone whos interested for future reference. This is so it is just in with the inner smaller wheel bearing which is roughly 52mm OD so it doesnt clamp against 2 seperate moving bearings meaning the spacer could get damaged or damage the bearing.

Got abit of a problem with my clutch cable not returning back out once clutch pedal is pressed down, i dont know if mayber the cable is getting stuck on the outer sleeve maybe but its all connected up correctly.

Anyone tried the spoox BE cables??

Has anyone got a part number for the CPS?

Want to make im ordering the correct one.

jsd how did u get on with all of this?

my calculations turned out that way. maybe someone will come in handy


http://www.drive2.ru/l/3430202/

Hi, I was wondering if any one had a part number for the rear engine mount/bearing mount? Been hunting high a low for one. Got one from a 1.6 hdi berlingo coming but if some one has a part number for a new item from pug/citroen even better.

Cheers! :)