Rear disc hub replacement
Hi folks,
Probably going to be doing nearside rear wheel bearing. I know from trying to remove the hubs off my old axle (disc hubs by the way) that they fall apart and leave the inner race on the stub. I also realise that the best plan is to buy the hub with bearing already in and fit that. As far as getting the old race off, I will probably just cut it off. Thing I wondered was, is it easy enough to fit the new hub - given that the old inner race gets stuck on? Is the inner bearing on the new hub going to bind up ? Heat the hub perhaps before fitting? Cheers Craig |
Should be ok to just make surr the stub is spotless, grease it up and then push it on.
|
Cheers my man.
|
All times are GMT. The time now is 15:35. |
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.