Ecu/ loom question.
Ecu/ loom question.
If you didn’t know I did my vts swap last year it’s a 2000 3 plug VTR and I fitted a 2003 3 plug vts lump. For whatever reason it would not fire on the vts ecu, sent it off to be unlocked and tried a different ecu and still nothing. However is runs perfectly on the original VTR ecu and I’ve since done 14k miles on the VTR ecu running the 16v engine. Only thing I’ve noticed is it’s only revs to 6.2K so presume that’s down to the VTR ecu. I’m looking to fit cams so would need to be remapped but I’m unsure you could plug the vts ecu in, get it mapped and be all good. Or mapping the VTR ecu to run the cammed 16v engine. Alternatively I have a complete spare engine with a single plug loom and ecu so I could convert the engine over to a single plug and go from there. Any ideas on why the vts ecu wouldn’t work can only presume it’s something in the loom as the car has run for over a year on the vtr ecu. |
You can't use a VTS (Magneti-Marelli) ECU on a loom for a VTR (Bosch) ECU because the pinouts are very different.
You'll be lucky if you haven't damaged it. Likewise, you really really shouldn't run the 16v engine on the 8v ECU for several reasons, the fueling will be rich at low and mid-range speeds where the 8v has better volumetric efficiency, and then it will be lean, very lean, at high revs where the VE of the 16v is better and you won't be getting the full range of performance because the rev limit of the VTR ECU is lower. |
Quote:
Knew the vtr ecu would have some downsides but i've ran it like this for over a year now get good mpg |
All times are GMT. The time now is 14:46. |
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.