Saxperience - Citroen Saxo Forum

Saxperience - Citroen Saxo Forum (http://www.saxperience.com/forum/index.php)
-   General Chat... (http://www.saxperience.com/forum/forumdisplay.php?f=11)
-   -   106 Gti Engine loom plug identification (http://www.saxperience.com/forum/showthread.php?t=475430)

karl_mh 11th June 2018 21:17

106 Gti Engine loom plug identification
 
2 Attachment(s)
Lets start with facts.....i'm crap at wiring identification even with the Haynes wiring diagrams and since i haven't removed an engine loom i'm struggling to identify what is what. I have been trawling the forum and google images to try and figure out what is connected to what without success.

Excluding the obvious - 2 x engine to interior loom plugs and ECU plug i'm stuffed!

Ive attached photos of the engine loom with coloured rings around each plug in the hope someone might recognise what is connected to what.

Once identified i'm stripping back the loom to relocate the ECU plug behind the glove box and to make it more difficult the engine and box are not fitted.

Chipwizards 12th June 2018 08:36

Rather than putting coloured rings around them number them then I can list what is what accurately.

karl_mh 12th June 2018 18:49

2 Attachment(s)
Good suggestion, i have now allocated all the plugs a number and TBF even i can make sense of it now - Here goes.

karl_mh 15th June 2018 14:13

106 Gti Engine loom plug identification
 
3 Attachment(s)
I’ve started stripping the engine loom back but wondering what the hell this relay / unit is.

Any ideas?

Attachment 18168Attachment 18169Attachment 18170


Sent from my iPhone using Tapatalk

MartinObviously 15th June 2018 17:36

That big relay is the fuel injection relay.

It controls the fuel pump and bridges loads of other connections for the ECU. Definitely keep your snips away from it hahaha

karl_mh 15th June 2018 18:59

1 Attachment(s)
Oh dear!! i've had to cut 7 wires to allow the ECU plug & harness to be located in the correct position to go through one of the bulk head grommets behind the servo.

These will be extended this evening, do you think by extending the 7 wires i would have issues with the fuel injection system?

At least i know what it is and does now!

Chipwizards 16th June 2018 10:40

1: Lambda
2: Reverse light switch?
3: Suppressor- bolts to the head
4: Coil Pack
5: Temp 1
6: I can't see what the connector is in the picture
7: Idle valve
8: Air Temp Sensor
9: TPS
10: Temp 2
11: Vehicle Speed Sensor
12: Knock sensor
13: Starter Motor
14: Oil Temp
15: ?
16: Starter-Alternator Main cable
17: MAP sensor
18: Main Relay
19: Tank vent valve
20, 21 and 23: Alternator
22: Oil Level sensor

karl_mh 17th June 2018 16:50

Result!! thanks for your time & effort:y:, i'll start labelling everything up tonight and i will take a better pic of No 6.

AXracing 18th June 2018 20:35

Chipwizards definitely knows his stuff with these cars and can do magic with tuning them.

Chipwizards 20th June 2018 20:27

Quote:

Originally Posted by AXracing (Post 6553557)
Chipwizards definitely knows his stuff with these cars and can do magic with tuning them.

Your cheque is in the post.

:-D


All times are GMT. The time now is 16:43.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.