sub and amp
 

hi i have a sub and amp and i know where each wire should plug in but i dont know where to feed the wires from one side of car to the other can any 1 post any pictures or let me know where to feed them ?

watch this video to get a rough idea.

Read this post for som help.

You will need to remove your front and rear seats so grab yourself a 6star screwdriver set. (i dont know what they are called)
you might need some glue to fix the carpet back down.

take your time, dont rush and try not to stress out :y:

i justed lifted the carpets up by the side of the door was quite a simple job, then used the while from my bonnet realease to get the wire to my battery

Torx :y:

can you not do it without removing seats

you can use the carpet up that runs flush to the door, along the side of the car in other words...

Actually I was lazy and didnt remove any seats.

The rear base seat just pulls out so get that out the way (no screws or anything needed).
Then I lifted the carpet under the passenger seat up by hand, jammed the wires down till I could reach them from behind the carpet under the daashboard.
Connected to the the Head Unit.
The other end I just pushed then under the rear seats by leaning them forward and then connected to the amp.

The lazy mans way of doing it!