engine wiring loom
 

How hard is it to replace the engine wiring loom, looking to replace as i have loads of broken connectors and basically the wiring is a mess.

Pierce of piss mate just disconnect all the sensors, and then route it back around the rear of the engine and back to the front again. Very easy to plug back in too as all the plugs only fit one socket in the area they lead too.

AS said pierce of piss mate just disconnect all the sensors:y::y:

start at the ecu end unclip the one under the wing then as your uncliping the old one start cliping the new one in very easy

thanks guys, was thinking it was gna be a pain in the ass cos of all the wiring that runs in the wings etc, but im assuming that these do not need to be touched thinkin bout it.