oil pressure sensor
 

hi all just have done a vts conversion to my vtr but is it necessary to have the oil pressure sensor as the wires have been cut off the loom would it affect the running off the car? as it seem to run very lumpy at tickover. it also has a chiped ecu so im wondering if that has any thing to do with it too

thanx mike

Don't know for sure but would assume that it would be fine without but you really should sort it out asap as it's abit cowboy otherwise. You have fitted a fuel return line, if they havnt got one on a vtr, not sure? Given it good service, clean throttle body, all sensors and pipes fitted/connected properly?

Lucky you got one, all i got is a stupid light, i would love a gauge!!

Thanx for the reply I will sort as soon as posable just so it can be elimated yes a fuel return was fitted but would the diameter of the pipe be a issue ? It's just had a service and all had it i'n bits to clean it not sure on the icv though is there any way to test them ?

The return pipe on mine is the same size as the flow. As for testing it I don't know but they all get caked in crap so take the tb off and give the whole lot a clean.

ok its my last resort so i will give it a try my main concern is the ecu not sure if its that that is playing up or not because off the chip

I've a spare one that came with an engine I bought, it's a single plug ecu. More than welcome to try it, not sure if it's locked though.

i also have a spare ecu for a vts but its not unlocked so ive hit a dead end riliits all clean inside now but still have the same issue think im just gona have to get a unlocked on