Badge-less grill
 

Got one of these ages ago but never bothered trying to fit it.

Obviously i have the mesh its self attached to the grill.

Wondering what is needed to attach the actual grill to the car, Bearing in mind my origional one is only held on via the under chevron screws.

Thanks

should be 7 torx size 20 screws, get stuck in and you'll instantly see where they are, done mine 5 mins ago haha!

Any thread size in particular? i can grab bolts n what ha ya from work rather than buying torx screws.

+ from looking at the grill it looks like the prongs would come through the holes or do they sit flush?

thanks

they should just sit flush,
can't help about the screws actul thread size though, although they looked similar to plaster board screws in that they were short and stubby, however plaster board screws are wayyy to thick to fit, could always just go though a screw tray trying diffrent size's ones bound to be close..