car isn't starting
 

i have recently installed my new loom, injectors and so on. i've tried to start the car but it doesn't start but turns over! the fuel pump is priming constantly and im not sure what to do?

i have a s1 rallye fuel rail with 3 input point on it and i'm not sure what goes where?

any ideas?

Is it trying to turn over? If no it could be the starter motor. If yes but its not firing could be the spark plugs.

its trying to start but just isn't going but the fuel pump is priming constantly so im guessing its not getting enough pressure?

Did it say the fpr pressure on what you bought?

Sent from my GT-I9100 using Tapatalk 2

i have the fpr on the s1 fuel rail but not on the furio one, was thinking would me taking the fpr of the s1 rail and putting it on the furio one work?

But if its like a 4 bar pressure fpr your pump wont be able to reach it...

Sent from my GT-I9100 using Tapatalk 2

its a 3 bar mate

Should be good for pressure

Sent from my GT-I9100 using Tapatalk 2

but would the fpr from the s1 rail fit the furio one?

Most Poss yeah

Sent from my GT-I9100 using Tapatalk 2

guess ill try tomorrow then!

As I said just re create what and how it should be, on the fuel pump.