lowered driveshaft problem help!
 

me and my mate lowered my car yesterday by 55mm on front and matched on rear and since having it down my driveshaft messed up. It keeps poping out as if its not long enough.
any suggetions or has anyone expirenced this before
cheers

raise that mo fo!

which side is popping out? you checked the driveshaft nut is tightened up and locked into place?

popping out?, have you put the nut back one right/tight enough?
its the strut in straight?

when the driveshaft is pushed right in it dosent come out far enough to get the driveshaft nut on the strut. its in bits now just trying to wirk out what to do. has no one had this problem when lowering. i think as the camber has come out due to lowering. that its pulled it the strut to far out.

is it the passenger side m8? if so check all bushes for play or even engine mounts, as they shuldnt pop out that easy. passenger side is worst for doing it. mite be worth jaccking car up and feel for any play, also check gear box n engine mounts. hope this helps.

its on the drivers side and all seems good and tight as it was all done yesterday mainly using impact drivers ect

wots the condition of the shft and cv? no clicks, rattle or any funny noises, could be a worn cv maybe??