Wednesday 10th October
Bottom end cleaning commences
Had a bit of spare time this morning, only an hour or so, so i thought id start to tackle the bottom end, condition wise it looked fine, but it was covered largely in what would be described as a spilt oil drum.
A roll of kitchen paper later, some scrubbing with a toothbrush and 2 sides are looking fairly clean. (Havnt started on the other 2 yet)
Ill give these another spray with gunk remover tomorrow to make sure and get all the little bits off that ive missed. Then whip over it all with a dremmel attachment of some sorts.
Ill then be hammeriting the bulk of it to keep it fresh and clean and start adding bits on again (if i can remember where the hell they go) before the head arrives back.
