Quote:
Originally Posted by Predator_VTR
yeah mate they should be fine, they will probablies be quite bright actually, but remember you can dim them
only pointers is to test the led after you have soldered one in, do one at a time, take one off put one on, you can easily tell which ones you havent done because they will be neat 
when doing round the ribbon connectors be very careful you can easily burn them |
ok thanks for that, iv just been told that mark1 dials arent these leds???? is this true???? what bulbs are they if not these plcc smd
helppppp pleaseeeeeeeeeeee
