Quote:
Originally Posted by Sneakydevil89
|
If you've got the metal clip loose then great.. If not i think the bottom end of it, that's clipped into the actual ECU unit needs to be pushed towards the bulkhead.. Then it should pivot around a little clip at the front end of the ECU unit. If you pull it right round on this clip it will eventually lift free. Then with it unplugged you need to take off the rubber bit that seals the wires in.. and under there are two screws. Undo them, then undo the other screw.. push a nail through and it should work.
Sorry if that was just a big disorganised mess... maybe someone else can put it better
