Quote:
Originally Posted by adsayer
shot blast ideally... but get in there with a drill on a wire brush as you suggested... take it back so that you've got a nice clean matt bare metal finish then then depending on roughness, sand with 400/800 grit and then prime... build up the layers the get the wet sanding on the go, spray colour... 100% LACQUER!!!!! otherwise the finish will go to shiiiit in no time.
ads
|
If only i could rep
Cheers guys.. Will take a few days to do per wheel i know.
1 can per wheel? Obv i'm not doing inside of the wheel, just the outside.